Home-made mast extender
If you've just broken a mast don't throw it away - you can easily make something useful out of it!
Faced with a long wait for a new 460 mast after my old one broke, I needed a backup plan in case I wanted to sail. I briefly considered one of the "Carbon Extender" things to extend a 430 mast (e.g. the North/Duotone or NeilPryde ones below), but immediately ditched the idea when I saw how expensive they are, and read that most people say that they are a terrible idea.

However, I then found these threads on seabreeze and Windsurfing.nl about making your own, which got me thinking. Seeing as I had a broken mast anyway this seemed like a very good idea.
What you need to do is:
- Take the bottom section of your old mast (assuming that it's not broken at the bottom!) and stuff it up the mast that you'll be extending until it's just a snug fit.
- Mark the position on the old mast by drawing around the base of the outer one.
- Remove from the mast and cut off the top section 20cms above the line that you marked.
- Now cut off the part 10cm below the line that you marked. This piece that you've cut will be the ferrule.
- Decide how long an extension you want:
Minimum 30cm to allow room for your normal mast extension, maximum 40cm or the boom will be too low on the extended mast.
Before you go any further, double-check that you will not need to put your mast extension into the "extender" by more than the available space, i.e. the chosen length minus 10cm for the ferrule. If necessary make a slightly longer extender or use a little bit less ferrule inside. This will of course depend on how much extension your chosen sails need.
- From the remaining piece of mast (the old base/foot), cut the top off to leave the extension length that you want (e.g. 30cm).
- You will now need to take a sander and gently sand down the lower 10cm of the ferrule until it will slide into the top of the extender.
It should be a fairly tight fit but leave room for some epoxy. (What you're doing here is removing the taper that the ferrule section will have and the base will not).
- Wrap plenty of masking tape around the ferrule above the marked line so that it cannot slip further into the extender (i.e. 10cm remains below the tape).
- Mix up some epoxy resin and smear it over the lower 10cm of the ferrule (and maybe some inside the top of the extender) and push the ferrule in up to the tape.
- Clean any epoxy from the join between the extender and ferrule/tape and remove any excess epoxy from the inside joint, working from inside the base.
- Leave to dry and clean up the ferrule joint if necessary when done.
- Sand down the top of the ferrule where it was cut, to remove any nics or cuts that might lead to splits (or cut your hands).
Keep it in your kit box and you've now got the option of using a smaller mast if your next size up ever breaks, or if you find you've forgotten to pack it!
An extended mast is going to feel softer and may not work so well, but it's better than being stuck on the beach with no mast at all, and if you're very light it might even work better!
This example is for SDM masts but I guess it would work for RDMs too. It might not work if your broken mast is one of the "Drop Shape" types.
The result:
This is the one that I made (it's exactly 30cm long to make a 430 into a 460)
